Forget Nissan Qashqai Key Fob: 10 Reasons Why You Don't Have It
Reasons Why Your Nissan Qashqai Key Fob Won't Work
The Qashqai's greater dimensions give it an SUV-like ambiance. Its ride on 19-inch alloy wheels on Ti and STL versions may also be a bit firm. The front tyres of Qashqai are also prone to losing grip on rough surfaces, and the CVT could occasionally display a wrist-flexing torque steering.
This is typically caused by a dead battery that can be replaced in just a few minutes. Make sure that the replacement battery is the same size, voltage, and specification.
Water Damage
One of the most common reasons a Nissan key fob will give the "key ID is not correct" message is due to water damage. The key fob comes with rubber seals that protect the electronic chip inside, but long-term exposure to moisture could cause it to stop functioning properly. It's normal to see this when your key fob was dropped into the ocean or in a pool. It can also occur when it becomes wet from rain or soapy hands.
If your key fob has been exposed to water over an extended period of time, you may need to clean it with isopropyl, or an electronic cleaner. It could also require to be sent to a professional for repair or replacement.
If your key fob is in need to be replaced, it's quite simple to do. Make sure you have the correct multipack (CR2032, 3V). Open the front and rear cases using the flat-head screwdriver. You'll have to remove the clips for retaining metal and then push out the battery that was in place, and then insert the new one. Reassemble the fob and replace the mechanical key. Verify that it is working correctly. If it isn't then you'll have to take it to a Nissan dealer or a professional auto locksmith for replacement of the chip. The chip is typically not damaged by water so it should not be too expensive.
Dead Coin Battery
The coin battery is another common reason that your Nissan Qashqai remote key fob might not function. The batteries typically last for 3-5 years but can go bad over time, especially if the fob is frequently dropped. It is possible to replace the battery with a new one, but make sure that it's the same size and voltage as the original. If you choose to use a brand new battery, it could cause the key to be assigned a different key ID. This could prevent it from being linked to your vehicle.
The most efficient method to change the battery of a coin in a Nissan Qashqai Key Fob is to pry it open with an small screwdriver that has a flat head. The screwdriver should be inserted into tiny notch at the bottom of the fob and move it around to separate the two halves of the key fob. Remove keyless ignition and replace it with a brand new one, observing the position of the old battery in the fob.
Examine the terminals to see if there is dirt or water damage prior to installing the new battery. If there is, clean the terminals with a tiny amount of isopropyl alcohol. Make sure that the pole cables are properly connected. They should be connected to the positive and negative poles of your battery.
Diagnostics of a fault
If your Nissan Qashqai key fob stops working after exposure to pure tap water or rain it could be an indication of a chip problem inside the. You'll need a new keyfob if you can't solve the issue by changing the battery. If the key fob didn't work after dropping it, it is likely that the chip inside was damaged. It is usually possible to get the key fob back to work once again if it is removed and clean the chip with alcohol and paper towels and then insert it back in.
A common error that you might see on the dashboard of your vehicle is "Key ID Incorrect." The vehicle is unable to recognize the key fob and consequently, won't allow the vehicle to start. The problem can be caused by a variety of factors like water damage, undetectable problems in the key fob's circuitry, or RFID interference.
The key fob will stop working when the 12 volt batteries are dead or do not provide enough electric current. This can affect the remote keyless system as well as central locking in your Nissan Qashqai, as well as stopping you from starting the engine with the key fob (if equipped with Intelligent Key). If you can't unlock or lock the door manually it is recommended to check the batteries in your key fob and make sure they are in good condition. You can also try re-inserting the battery to reset the transmitter.
Reprogramming
If the key fob was not submerged in saltwater it should be able to come back to life by a simple wash of clean water. You can also clean the electronic chip by using isopropyl or electronic cleaner. If none of these works then it might be time to replace the entire key fob with a new one.
If your Nissan Intelligent Key is still not working, it could be a problem with the connection between it and your car. Start by turning the ignition key without beginning the car. Repeat this process until the hazard light flashes two times. After that, turn the car off and remove the keys.
Open the fob compartment in your vehicle. It is typically located in the door jamb, on the handle for the driver's door or underneath an armrest. Locate the small button labeled "program" and press it. You will hear a sound after the process has been completed.
It's time to test your Intelligent Key to the test. Take a step away from the car, and press all the buttons on it. If the lights flash and the horn squeaks it means that the key has successfully linked to the Nissan. It is also possible to test it in close proximity.